2024-06-23, 06:47 PM
(2024-06-23, 04:43 PM)theskyhound Wrote: Hello,
Sometimes clever and simple designs have the side effect that they aren't obvious to new users. ;-). The SkyTools Schuduler has many different modes of operation, which determine what options there are, and more importantly, what output it generates. There isn't any switch to toggle these modes on the Scheduler. Instead, it looks at the properties of the selected imaging system to determine what mode to use. In particular, it looks at the Control System.
To answer your question, if you want to create a schedule that you can print to use to set up your AIR software, open your Imaging System, click on Control System, and select "Hand Controller / Manual Control." With that selected the Scheduler will generate a list that you can print out. It may be time to revisit the label for that selection. Maybe I can make it more clear. "Hand Controller" and "Manual" intuitively really describe what you wan to do.
I " think " I followed your instructions verbatim - I was able to generate a list ( see png file attached ) with the workflow recommended for a given night in the Scheduler.
Trying to print the report to a printer or to a pdf ( see attached ) the entire list is not printed out. I tried portrait and landscape mode, same result
Please advise - thank you again
ST4 printout.pdf (Size: 174.6 KB / Downloads: 4)