Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
External Guider setup - bug
#3
OK - but the problem is that if I leave the first 4 fields blank, and populate the guide camera parameters, I get an error when clicking OK: "Focal length is out of scope" - entering the focal length causes another error message about distance between the OTA and the guider - entering 0 there is then OK, the dialog closes; but the setting is not retained when reopening the imaging systems parameters for that device combination.
I think this dialog is a bit confusing at the moment.
Hope my explanations are clear enough...
Regards,
Rodolphe
Reply


Messages In This Thread
External Guider setup - bug - by Rodolgo - 2019-01-02, 05:04 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 05:25 PM
RE: External Guider setup - bug - by Rodolgo - 2019-01-02, 05:40 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 06:23 PM
RE: External Guider setup - bug - by Rodolgo - 2019-01-02, 06:34 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 07:07 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 08:07 PM
RE: External Guider setup - bug - by Rodolgo - 2019-01-03, 02:05 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)