Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
External Guider setup - bug
#1
Sad 
Hi
Not possible to enter the distance between the guider and the OTA in other units than arc min.
Help file specifies otherwise:

If you know the separation from other software, simply enter it in arc minutes and select arc min as the units. If starting from scratch it may be best to measure the distance between the center of the guider body and the center of the pick mirror in mm. When you enter this number, select mm as the units. This should get you pretty close. 

Screenshot
Reply


Messages In This Thread
External Guider setup - bug - by Rodolgo - 2019-01-02, 05:04 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 05:25 PM
RE: External Guider setup - bug - by Rodolgo - 2019-01-02, 05:40 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 06:23 PM
RE: External Guider setup - bug - by Rodolgo - 2019-01-02, 06:34 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 07:07 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 08:07 PM
RE: External Guider setup - bug - by Rodolgo - 2019-01-03, 02:05 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)