Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
External Guider setup - bug
#4
Hi,

Assuming this is for an external scope: you must enter non-zero values for the separation and focal length. Both are required.

What are the actual numbers for the separation of the OTA and guide scope (even if only approximate) and the focal length of the guide scope?
Clear skies,
Greg

SkyTools Developer
Reply


Messages In This Thread
External Guider setup - bug - by Rodolgo - 2019-01-02, 05:04 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 05:25 PM
RE: External Guider setup - bug - by Rodolgo - 2019-01-02, 05:40 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 06:23 PM
RE: External Guider setup - bug - by Rodolgo - 2019-01-02, 06:34 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 07:07 PM
RE: External Guider setup - bug - by theskyhound - 2019-01-02, 08:07 PM
RE: External Guider setup - bug - by Rodolgo - 2019-01-03, 02:05 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)